Product Image

Raspberry PI 2020 mount

Designed by: FreakErn

Because of the fact that i had some problems with the VORON case (no holes or wrong diameter), i took the original case, removed the outside holes for mounting it onto a vesa mount, added six holes into the bottom part itself and now i am Happy with that design.

You can easily use some hammer nuts like i showed in one picture and mount the PI where every you want it on your printer.

Parts you'll need:

2-3 x hammer nuts (on my cr-10 i used M4)
2-3 x screws fitting into your hammer nuts
4 x M2.5x6 for mounting the pi on the bottom part
4 x M3x20 for mounting the top part to the bottom part

Do not use washers inside the case for mounting the case to the 2020 extrusions, you could damage your PI if you short some connections.

I powered the PI by using Pin 2 and 6 of the GPIO's.

0.00

Raspberry PI 2020 mount (eg CR-10, AM8, Tevo Tarantula, Tevo Tornado) by FreakErn is licensed under the Creative Commons - Attribution license.

View on Thingiverse

Order Custom Print